Features

Model 17-0

For removing ball bearings, roller bearings, inner races and other tight parts if there is not enough space to use pulling hooks. Min pulling dia 5mm, max pulling dia 60mm

 

Model 17-1

For removing ball bearings, roller bearings, inner races and other tight parts if there is not enough space to use pulling hooks. Min pulling dia 12mm, max pulling dia 75mm

 

Model 17-2

For removing ball bearings, roller bearings, inner races and other tight parts if there is not enough space to use pulling hooks. Min pulling dia 22mm, max pulling dia 115mm

 

Model 17-3

For removing ball bearings, roller bearings, inner races and other tight parts if there is not enough space to use pulling hooks. Min pulling dia 25mm, max pulling dia 155mm

 

 

The separators of series 17 are used together with the extractors of series 18 for extracting ball bearings, roller bearings, inner rings and other parts lying flat in trade, industry and workshops when there is not enough space for extractors. The separating-pulling process is able to separate those parts gently before they can be pulled off from the outside. Compared to the 15 series, the 17 series is particularly handy because the separating jaws are clamped quickly and centrically by a pressure spindle

Use

Press the sharp cutting edges of the separator behind the part
Clamp the separating jaws by actuating the pressure spindle and ensure that the separating blades are seated up to the stop under the part to be removed
Screw the puller bolts into the threaded holes of the separator as far as they will go
Hold the separating device and pull off the part in question safely and carefully by tightening the clamping nut